unique handmade beaded jewelry out of string and acrylic beads
TRANSCRIPT
Unique Handmade Beaded Jewelry out of String
and Acrylic Beads
I like to design jewelry that you can use in various
ways with just a few inexpensive supplies. Tie knots,
add beads, unite them together and create a unique
handmade beaded jewelry bracelet and necklace.
With just the common Forward Knot, you can finish a
bracelet successfully. Cool, isn’t it?
Supplies needed:
8mm Colorful Acrylic Bead
6mm Colorful Acrylic Bead
1mm Nylon Thread
Lighter
Scissors
Here are a few images of my latest project for unique handmade beaded jewelry. While practicing, you
may need simply inches of neon nylon-colored string and beads. This tutorial is easy to follow!
How to make the unique handmade beaded jewelry?
Step 1: take 8 strands of 80cm long nylon
thread and divide it into two equal groups. Tie
into a bunch using a Snake Knot 10cm from the
start.
Step 2: on the right side, take a strand and
use it as the holding end while the other 3
ends will be the main working end. Start to
tie forward knots with each end twice.
Do the same process for the left side.
Step 3: pick up the two holding end which should meet at the center, use either one to tie two
forward knots around another. And this will be the starting point of the entire project for this unique
handmade beaded jewelry.
Step 4: slide one 6mm acrylic bead on the outer string. Make forward knots around the new
holding end, from the center to out.
Do the same to the other half.
Step 5: Hold the two inner ends and insert one
8mm acrylic bead onto them.
Work the forward knots inwards with the 3 working
ends on both sides.
Repeat Step 3 to close off the circle.
If you are like me, you may already be enchanted by its brightness and vibrancy. This unique
handmade beaded jewelry may also be classified as an innovative friendship pattern. Hope you
guys will love it.
Search for diverse beads in your handmade jewelry, welcome to visit our webpage at:
http://www.pandahall.com/
Step 6: work the pattern in step 5 for the desired
length of your bracelet.
Finally, finish the bracelet with a snake knot as
before. Reserve the two holding ends on two sides.
Step7: Overlap the ends on a flat surface,
and then design a closure by tying 6 or 7
square knots with an extra strand. Remove
excess cord and secure with a lighter.
Thread one 6mm acrylic bead on the two
remaining ends on each side, secure with an
overhand knot.
Melt the endings with a lighter and
congratulations!