the eldredge knot tying instructions

The Eldredge Knot Tying Instructions 1. Start with the wide end of the tie on the left and the small end on the right. The tip of the wide end should rest at the top of your belt buckle. Only move the active (small) end. 2. Small end over the wide end to the left. 3. Under the wide end and to the right. 4. Up to the center, towards neck loop. 5. Through the neck loop and to the left. 6. Across the front, to the right. Then up into the neck loop from underneath. 7. Down to the left and around the back of the wide end to the right. Keep this part loose. 8. Bring it across the front towards the left and through the loop made in the previous step. 9. Pull the small end towards the left to tighten.

Upload: bhavani-testone

Post on 13-Aug-2015

29 views

Category:

Engineering

6 download

Report

Download

Embed Size (px):

TRANSCRIPT

The Eldredge Knot Tying Instructions

1. Start with the wide end of the tie on the left and the small end on the right. The tip of the wide end should rest at the top of your belt buckle. Only move the active (small) end.

2. Small end over the wide end to the left.

3. Under the wide end and to the right.

4. Up to the center, towards neck loop.

5. Through the neck loop and to the left.

6. Across the front, to the right. Then up into the neck loop from underneath.

7. Down to the left and around the back of the wide end to the right. Keep this part loose.

8. Bring it across the front towards the left and through the loop made in the previous step.

9. Pull the small end towards the left to tighten.

10. Up to the center, towards neck loop. Down through the neck loop and to the left.

11. Up to the center, towards neck loop. Down through the neck loop and to the right. Keep this part loose.

12. Across the front towards the left and through the loop made in the previous step.

13. Pull the small end towards the left to tighten.

Page 2: The eldredge knot tying instructions

14. Tuck the rest of the small end behind neck loop on the left side.

15. Strut your stuff.

Page 3: The eldredge knot tying instructions

The Trinity Knot Tying Instructions

1. Start with the wide end of the tie on the left and the small end on the right. The tip of the wide end should rest at the top of your belt buckle. Only move the active (small) end.

2. Over the wide end to the left.

3. Up into the neck loop from underneath.

4. Down to the left.

5. Around the back of the wide end to the right.

6. Up to the center, towards neck loop.

7. Through the neck loop and down to the left.

8. Across the wide end to the right. Up into the neck loop from underneath.

9. Down through the loop you created in the previous step. Keep loose.

10. Bring the small end around the back of the wide end to the right.

11. Bring it across the front towards the center and through the loop created in the previous step.

12. Tighten and tuck the rest of the small end behind neck loop on the left side.

13. Hypnotize the throngs of onlookers.