Sunflower Ring Tutorial

For more tutorials visit: slideshare.net/cassieibellie

List of Materials and Tools

Supplies needed for making a memory wire ring:

• 8mm Agate Bead• 4mm Coconut-Brown

Seed Beads• 3mm Yellow Seed

Beads• 3mm Green Seed

Beads• 2mm Coconut-Brown

Seed Beads• Memory Wire• 0.3mm Tiger Tail Wire• Round Nose Pliers• Side Cutting Pliers• Wire Cutter Pliers• Hot Melt Glue Gun

(optional)

Step 1Make the flower disk by using brick stich technique1st, cut a 60cm piece of tiger tail wire and then slide the 6mm agate bead to 6cm from the other end;

2nd, thread the wire through the bead from left to right to make a loop around the outside of the bead.

3rd, string two 2mm brown seed beads, then pass the wire under the loop around agate bead. Pull the wire to make the two seed beads rest as picture shows. Finally, weave the wire back up through the second seed bead. Tighten the wire then;

4th, slide one 2mm seed bead, pass the wire under the loop around agate bead, then back up through the newly added seed bead. Pull the wire tightly;

5th, repeat the 4th procedure until surround the agate bead with 2mm seed beads;6th, when exiting the wire at the last seed bead, you should continue to pass it down through the first seed bead and then up through the last seed bead. Pull the wire tightly;7th, add two 4mm brown seed beads and do the brick stich pattern as did

with the 2mm beads.

Step 2Make the petals with yellow

seed beads

1st, once exit the wire at the last 4mm brown seed bead, slide eight 3mm yellow seed beads instead;2nd, pass the wire back through the last but one seed bead;3rd, string another eight 3mm yellow seed beads;4th, pass the wire under the exposed wire between two 4mm brown seed beads;

5th, tighten the wire and then repeat the procedures 1~4 for the rest petals.

Step 3Prepare the memory wire ring

base

Cut a 4-coil memory wire, loop one end with round nose pliers. Then, string the 3mm green seed beads to cover the wire coils. Finally, make a simple loop at the other end to secure the beads stay in place.

Step 4Assemble the beaded flower with memory

wire ring base

1st, take the semi-finished seed bead sunflower, pass the working wire end down through its adjacent 4mm brown seed bead and 2mm brown seed bead;

2nd, take the beaded memory wire ring and cross the two wire ends through the two loops twice or more times;

3rd, knot the wires firmly and then trim off the leftovers;

4th, seal the part between sunflower and ring with thick glue if necessary.

Sunflower Ring Done

If you have any questions concerning this tutorial, pls, do not hesitate to contact me.

www.pandahall.com