sto work pack – rf box partsloke.as.arizona.edu/~ckulesa/binaries/sto/sto work pack - elect...
TRANSCRIPT
STO Work Pack – Elect Box Parts
11 Different Parts;23 Total Parts
8/18/09
Note Parts 7 – 11 are repeats of parts 5, 6, 7, 9, & 10 in the RF Box Work Pack
1] ELECT BOX BASE PLATE
6-32
4-40
ALL OTHERHOLES SEE NEXT PAGE
Qty: 1 Mat’l: 6061-T6 (17.1”x15”x.25” stk)
¼-28
#4
#6
#10
100° C-Sink This Side
FRONT SIDE –BACK SIDENEXT PAGE
Helicoil Tapped Thru
1] ELECT BOX BASE PLATE
ALL OTHERHOLES SEE PREV. PAGE
#4
#6
100° C-Sink This Side
BACK SIDE –FRONT SIDEPREV. PAGE
2] Asst Electr Box Top
Flat Pattern Size: 20.9” x 16.1”
Qty: 1Mat’l: .035” thk sheet,6061 or 5052 Al
3] Bias Electr Box Top
Flat Pattern Size: 18.7” x 15.1”
Qty: 1Mat’l: .035” thk sheet,6061 or 5052 Al
4] Preamp Box Top
Flat Pattern Size: 19.3” x 7.8”
Qty: 1Mat’l: .035” thk sheet,6061 or 5052 Al
5] Bias Board Thermal Standoff
Qty: 14Mat’l: Ø1” round bar stk,6061-T6
Part Length = 1.250” +/- .003
10-32 Helicoil Tapped, Both Ends
6] Bias Card HX SinkQty: 1Mat’l: 6061-T6
Part Size = 1.69 x 1.00 x 0.646” +/- .005
6-32 Helicoil Tapped, 5 Holes
#4 100° C-Sink Thru, 2 Holes
7] RF Box Mid Aft Bracket
Qty: 1Mat’l: 2.5” x .25” angle,6061-T6 or Better
All Holes Thru
3.0”
Note: Identical to Part 7 in RF Box Work Pack
Note: Mirror to this part not used in this work pack
8] RF Box Upper Aft Bracket
Qty: 1Mat’l: 2.5” x .25” angle,6061-T6 or Better
9] RF Box Upper Fwd Bracket
Qty: 1Mat’l: 2.5” x .25” angle,6061-T6 or Better
Note: These two parts are mirrors of each other
All Holes Thru All Holes Thru
1.35”L
Note: Identical to Parts 5 & 6 in RF Box Work Pack
10] RF Box Lower Aft Bracket
Qty: 1Mat’l: 2.5” x .25” angle,6061-T6 or Better
11] RF Box Lower Fwd Bracket
Qty: 1Mat’l: 2.5” x .25” angle,6061-T6 or Better
Note: These two parts are mirrors of each other
All Holes Thru All Holes Thru
2.38”
Note: Identical to Parts 9 & 10 in RF Box Work Pack