Step 2 Use rubber pads under foot

mounts to level the SmartBox if required

Step 3 Mark Position of Base Mount

Frame

Step 4 Remove Base Mount Frame

Step 5 Reposition Base Mount Frame.

Step 6 Drill the correct Hole Position.

Check for Obstructions Underside Bin.

Step 1

Lower SmartBox into Load Bin

Step 8 Bolt down with Load Spreaders

under side of Load Bin

Step 9 Drill for Wire Harness Feed

Step 10 Slowly lower SmartBox,

Connect the Wire Harness

Step 11 Feed Wire Harness direct to Battery, connect with fuse.

Step 12 Once in position, apply washer

+ split pin

Step 7 Apply Tectile in new drilled

Hole