power electronics

14
POWER ELECTRONICS Instructor: Eng.Moayed N. EL Mobaied The Islamic University of Gaza Faculty of Engineering Electrical Engineering Department م ي ح ر ل ا ن م ح ر ل ه ا ل ل م ا س بEELE 5450 — Fall 2009-2010 Lecture 27

Upload: bly

Post on 10-Jan-2016

74 views

Category:

Documents


4 download

DESCRIPTION

بسم الله الرحمن الرحيم. The Islamic University of Gaza Faculty of Engineering Electrical Engineering Department. POWER ELECTRONICS. EELE 5450 — Fall 2009-2010. Instructor: Eng.Moayed N. EL Mobaied. Lecture 27. Three switches conducting. - PowerPoint PPT Presentation

TRANSCRIPT

Page 1: POWER  ELECTRONICS

POWER ELECTRONICS

Instructor: Eng.Moayed N. EL Mobaied

The Islamic University of GazaFaculty of EngineeringElectrical Engineering Department

الرحمن الله بسمالرحيم

EELE 5450 — Fall 2009-2010

Lecture 27

Page 2: POWER  ELECTRONICS

Three switches conducting

The conducting sequence is as follows (each device conducts for a 180o period):

Page 3: POWER  ELECTRONICS
Page 4: POWER  ELECTRONICS

Three conducting devices- line voltage and current

Values of line voltage and line (also phase) current for 60o intervals are shown, from which the waveforms are constructed. The other two lines have identical values, displaced mutually by 120o

Page 5: POWER  ELECTRONICS

Three conducting devices- line voltage and current

Values of line voltage and line (also phase) current for 60o intervals are shown, from which the waveforms are constructed. The other two lines have identical values, displaced mutually by 120o

Page 6: POWER  ELECTRONICS

Comparing rms line currents

Page 7: POWER  ELECTRONICS

Comparing rms line currents

Two switches conducting

Page 8: POWER  ELECTRONICS

INVERTER HARMONICS

Page 9: POWER  ELECTRONICS
Page 10: POWER  ELECTRONICS

INVERTER HARMONICS

Page 11: POWER  ELECTRONICS

INVERTER HARMONICS

Page 12: POWER  ELECTRONICS

SINUSOIDAL PULSE-WIDTH MODULATION

One of the methods used to reduce the low frequency harmonics in the inverter waveform is sinusoidal pulse-width modulation. In this method, a reference copy of the desired sinusoidal waveform, the modulating wave, is compared to a much higher frequency triangular waveform, called the carrier wave The resulting drive signals cause multiple turn-on of the inverter switches in eachhalf-cycle with variable pulse width to produce a quasi-sine wave of load voltage. The pulse width increases from a very narrow width at the start of each cycle to a maximum width in the middle of each cycle. Then the pulse width reduces again after maximum until its minimum width at the end of the half-cycle period.

Page 13: POWER  ELECTRONICS

SINUSOIDAL PULSE-WIDTH MODULATION

Typically in the comparator when the sine wave voltage exceeds the triangular wave voltage, the load voltage is +Vdc, and when the triangular wave voltage exceeds the sine wave voltage, the load voltage is -Vdc.

Page 14: POWER  ELECTRONICS

SINUSOIDAL PULSE-WIDTH MODULATION

End of Lecture

Problem set : (SELF-ASSESSMENT TEST, PROBLEMS) due to 6/1/2010