polycon® ae - straumann€¦ · polycon® ae pmma-based acrylate polymer. strong acrylate polymer...
TRANSCRIPT
polycon® aePMMA-based acrylate polymer
Strong acrylate polymer for up to full-arch, full-contour temporary restorations
STABILITY The material properties provide excellent compound stability for easy handling and reliable prosthetic outcome
EFFICIENCYpolycon® ae is especially suited for full-contour temporary restorations for high efficiency
STRENGTHThe PMMA-based acrylate polymer provides high strength for indications up to full-arch
Centralized milling
490.387.indd 1 19/08/2019 13:50
2
Available shades ► polycon® ae restorations (available through our CARES® centralized milling solution) are
available in 6 shades: Bleach, A1, A2, A3, B1 and B2
Available indications ► For temporary restorations ► For up to full-arch
Recommended indicationPossible indicationNot possible indication (n/a)
TOOTH-BASED
n/a n/a n/a n/a
Inlay Onlay Veneer Partial crown Coping
Full-contour crown
Telescopic crown
Bridge/bar framework
Full-contour bridge
Vestibular veneering
ABUTMENT-BASED (AVAILABLE WITHIN THE CARES® X-STREAM™ SOLUTION)
Coping on Ti-Base
Full-contour crown on Ti-Base
Bridge/bar framework on Ti-Base
Full-contour bridge on Ti-Base
Coping on CADCAM abutment
Full-contour crown on CADCAM abutment
Bridge/bar framework on CADCAM abutments
Full-contour bridge on CADCAM abutments
Bleach A1 A2 A3 B1 B2
490.387.indd 2 19/08/2019 13:50
WorkflowSTEPS OPTIONS
Finishing PolishingLayering
Cementing Temporary cementation
Physical propertiesPROPERTIES VALUE
Material PMMA
Biaxial flexural strength [MPa] ≥ 50
Water absorption [µg/mm³] ≤ 40
Water solubility [µg/mm³] ≤ 7.5
Chemical compositionELEMENTS WEIGHT
Polymethyl methacrylate (PMMA) > 98 %
Methylmethacrylate < 1 %
Dibenzoyl peroxide < 1 %
Pigments < 0.5 %
3
490.387.indd 3 19/08/2019 13:50
Preparation guidelines ► The preparation shall not have angles or sharp edges ► The shoulder preparation shall be with rounded inner edges and/or chamfer ► The cross-sections shall be adjusted in relation to the total size of the restoration ► The transition from a connector to a crown or coping shall be rounded
Wall thickness
≥ 9 mm²
Connector cross-section
MINIMAL RESTORATION DESIGN
Restoration wall thickness
≥ 0.6 mm
International HeadquartersInstitut Straumann AGPeter Merian-Weg 12CH-4002 Basel, SwitzerlandPhone +41 (0)61 965 11 11Fax +41 (0)61 965 11 01www.straumann.com
© Institut Straumann AG, 2019. All rights reserved.Straumann® and/or other trademarks and logos from Straumann® mentioned herein are the trademarks or registered trademarks of Straumann Holding AG and/or its affiliates.
490.
387/
en/B
/00
08/1
9
490.387.indd 4 19/08/2019 13:50