Study the ground profile and derive the Geotechnical parameters for the analysis Location plan & Geological cross- section using gINT Recommending the number of bore holes and depth for soil investigation according to the tender requirements Preparing the Geotechnical Inception report, Geotechnical Interpretative report, Geotechnical Design report as per BS 5930 Preparing proposal, bill of quantities and specification for geotechnical investigation Bearing capacity, Settlement of soil & rock and Modulus of subgrade reaction calculations Settlement analysis of Isolated and raft foundation using P-Disp Group Settlement analysis of isolated foundation using P-Disp Check for Uplift pressure and total and differential settlements Design of Raft, Strip, Pad foundation Design of Pile foundation using AASHTO method, Clayton (Decourt) method and IS method Analysis of single pile and pile group using Piglet Evaluate the stiffness modulus of piles Bearing capacity, Settlement, Uplift pressure and total and differential settlements and Modulus of subgradereaction Calculation of Tunnel Liquefaction assessment based on JRA (1996) and Iwasaki et al (1984) Earthwork settlement calculation for an embankment Clarify and reply to the CRS comments Slope Stability analysis using Geostudio 2004-SlopeW Stability of an open excavation supported by diaphragm wall using Plaxis 2D (version 9.0) The effects of settlements due to the construction of tunnel using Plaxis 2D (version 9.0