necklace making ideas-how to make bead necklace patterns
DESCRIPTION
Today I will show you the necklace making ideas of how to make bead necklace patterns, you only need prepare a few basic supplies and go with our tutorial step by step, the bead necklace patterns will be created.TRANSCRIPT
Necklace making ideas-how to make bead necklace patterns
Maybe you will feel a bit difficult after you see the
end-product drawing of the bead necklace patterns,
but once you master the way, you won’t feel it hard
any more.
Things you need in the “necklace making ideas”
project:
2mm blue seed beads
2mmtransparent seed beads
4mm clear seed beads
8mm blue abacus glass beads
Silvery chain
Nylon wire
Scissor
Lobster claw
Jumpring
How to make bead necklace
patterns:
Step1: finish a unit
1. Take enough elastic wire and slide an abacus glass beads on
the middle of the wire,
2. String a 2mm blue seed bead, an 8mm blue bead, a 2mm
white seed beads and a 2mm blue seed bead on both of the
two lines in order.
3. String cross an 8mm blue bead and fasten; now we have
finished the first unit.
Today I will show you the necklace making ideas of how to make bead necklace patterns, you only need
prepare a few basic supplies and go with our tutorial step by step, the bead necklace patterns will be
created.
Step2: repeat to string beads.
1. String a 2mm white seed bead, an 8mm blue glass bead, a 2mm white seed beads and a 2mm
blue seed bead on both of the two lines in order and then cross both ends of the two wires, tighten
it.
Step3: pay attention to the third units
1. When we move to the third units, you should
attention the way I thread. Slide an 8mm glass
bead, a 2mm white seed bead, a 2mm blue seed
bead, an 8mm glass bead and a 2mm blue seed
bead on the left wire in turn,
2. String a 2mm white seed beads an 8mm blue
glass bead and a 2mm white bead on the right wire
in turn, cross left end through the right end.
3. Thread an 8mm blue glass bead, a 2mm
blue seed bead, a 2mm white seed bead, an
8mm bead, a 2mm white seed bead and an
8mm blue bead on the right line, cross the
left end through the last 8mm blue bead on
the right line, tense the two lines.
4. According to the all steps of above
mentioned, you can finish the lower half of
the necklace. Snip off the excessive wire.
Step4: make a ring and finish the necklace
1. Use the beading technique of brick stich to make a ring.
2. Here is a way to connect two sides, cross the two ends through a 4mm white bead, thread two
lines downward and then string upward from the next bead until finish the whole ring, using the
rest wire to combine with the lower half of the pendent.
3. at last, cut off the redundant elastic wire and add on chain, lobster claw.
Since you have seen the whole introduction of
how to make bead necklace patterns, do you still
think the necklace making ideas of bead
necklace patterns are difficult to make now? I
believe you don’t think so.
Making more fabulous necklace pattern, please visit the page at:
http://www.pandahall.com/learning-center/Necklaces/grid-7-p1.html