metering plunger s bi a and diaphragm pumps sabi pompe api ... · api 675 requirements. special...
TRANSCRIPT
The MET 2 metering pump covers the range of medium and large capacities in the dosage and injection applications.The pump is a positive return type and is designed for continuous service. Its design allows the installation of a double acting arrangement to obtain very large capacities. During operation or standstill of the pump the stroke is continuously adjustable by means of a manual knob or by automatic control systems, pneumatically or electronically driven.The stroke variation is proportional within the whole adjusting range of 0-100% and guarantees linearity and repeatability of the flow in accordance with API 675 requirements. Special executions are available for applications where capacity less than 1 l/h and pressure up to 1500 bar are requested (i.e. catalyst injection in very high pressure processes).
Rod thrust: 1200 kgStroke length: 60 mmRPM Max: 200
Double acting heads in opposite side
193 RPM145 RPM 98 RPM 74 RPM 48 RPM
Pre
ssu
re b
ar
1000
1000 10000
100
10010
101
MET 2 Performances
For the hydraulic end thereare two versions available:plunger and diaphragm. The diaphragm head is hydraulically actuated and double diaphragm "Sandwitch type" with a monitoring system which allows failure detection.
Capacity l/h (Value based on 100% volumetric efficiency)
Metering Plunger and Diaphragm Pumps API 675MET 2 Type
SABI Pompe
ABIS
SABI Pompe
MET
2 S
erie
s - R
ev. 1
SABI SrlVia Sabin, 6 - 20019 Settimo Milanese (Milano) Italy - Tel. +39 02 335 148 16 - [email protected] - www.sabipompe.com
Pumping Heads
Typical high-pressure plunger pump withdouble ball valves
Typical diaphragm pump with double ball valves
MET 2 Type MET 2 dimensions (mm)
The dimensions are approximate and not binding
SABI Pompe
ABIS
145 110
195 520
780
505
100
234
806
302
170
148
186
148
186
400
472
545
680
135
o 22
2
Single acting
Double acting