lucky earth necklace jewelry making tutorial from ornamentea.com
TRANSCRIPT
-
8/9/2019 Lucky Earth Necklace Jewelry Making Tutorial from Ornamentea.com
1/1
Lucky Earth Necklace
Using your wire cutters cut four 20 strands
of Soft Flex from your Trio. Cut two strands
of your favorite color from the assortment.
Put a bit of glitter from your favorite secret garden in this tiny bottle. The
key unlocks the gate, the wishbone brings you luck while you visit. Dont be
daunted by the wordy directions, this necklace is all attened tube crimps
and simple stringing.
Thread all four strands through two size 4
crimp beads. Separate the four strands and
wrap them around the neck of the glass
bottle as shown. Tighten the crimp beads
along the wire until the bottle is secure.
Using your chain nose pliers atten each
crimp bead carefully.
Thread a size 4 crimp bead on the wires
on the right side of the bottle. Flatten
crimp inch from the previous attened
crimp. Thread a size 4 crimp onto the wires
and separate the four wires to t the vin-
tage repro key between the wires. Tighten
wires and atten crimp.
Materials needed:{All tools and supplies are available at
Ornamentea.comor atOrnamenteaor
in Raleigh, NC!}* 1 glass bottle with cork
* 1 vintage reproduction key
* 16mm Elaine Ray old bronze small lentil bead
* 12 mm Elaine Ray pewter Pop Dot bead
* 1 antique pewter wishbone charm
* 8 Titan glass lentil beads, 6 mm
* 8 Persephone glass lentil beads, 6 mm
* 16 Matte Raku soft brown Toho beads, 1.5 mm
* 9 gold plated crimp tubes, size 4
* 36 gold plated crimp tubes, size 2
* 9 mm antique brass spring clasp
* 3 inches antique brass cable chain
* Softex Serenity Trios
Tools needed:* Chain nose pliers
* Wire cutter
Tutorial
Tutorial copyright 2010 Bedizen Ornaments, Inc. www.ornamentea.com
Thread a size 4 crimp bead on the wires on the right side of the key.
Flatten crimp inch from previous attened crimp. Thread two of the
wires through the center of the 9 mm bead. Separate the two wires
and pair them up with the wires on the outside of the bead. Thread
each wire pair through a size 2 crimp. Flatten each size 2 crimp.
Optional: If you wish to keep your bottle closed for eternity put a small
amount of Diamond Glaze around the rim of the cork and press into
place.
Select one pair of wires and thread one of these wires through a single
lentil bead. Thread both wires through a size 2 crimp and position
crimp inch from previous attened crimp. Use your chain nose
pliers to atten size 2 crimp. Repeat this, alternating lentils and
triangle beads separated by size 2 crimps until you have added 8
beads to this side of the necklace.
Select the second set of wires emerging from the 9 mm Elaine Ray
bead and repeat step 5, beginning rst with a triangle bead and
continuing until you have added 8 beads to the strand.
Thread all four strands through a size 4 crimp bead and then throughyour extender chain. Thread the strands back through the crimp bead
and position smoothly before attening. Trim excess.
Repeat from step four to nish the other side of the necklace.
1
2
3
4
5
6
7
8