hitchins swimming pool

Download Hitchins Swimming Pool

Post on 06-Mar-2016

223 views

Category:

Documents

3 download

Embed Size (px)

DESCRIPTION

Double Protection Waterproofing for suspended swimming pool

TRANSCRIPT

  • Hitchins Product Presentation

    Is a special blend of cement, quartz sand and multiple activating chemical in powder form. Upon application the chemical will react to form insulable crystals that penetrate deep into the concrete. Type : Crystalline, Integral

    Consumption : 1 x coating @ 1,0 kg/ m

    Two component cementitious waterproofing system that has excellent flexibility and strength. It is used in situation where movement or cracking of the substrate is occuring or anticpated.

    Type : Cementitious membrane Consumption : 2 x coating @ 1,0 kg/ m

    FORMDEX PLUS:

    FORMDEX UNIFLEX:

    SWIMMING POOL

    (SUSPENDED STRUCTURE)

  • Hitchins Product Presentation

    APPLICATION PROCEDURE

    All surfaces to be waterproofed shall be cleaned by wire brushing, scraping or any other suitable means to remove dirt, grease, mould, etc.

    All concrete surface should be dampen prior to waterproofing application.

    Surface Preparation:

    All new concrete surfaces shall be cured for a minimum of 14 days before the Waterproofing can be applied.

  • Hitchins Product Presentation

    Formdex Plus: Mixing: Add 5 part of powder to 2 part of clean water by volume, and

    mix thoroughly for at least 3 minutes.

    Mix only sufficient material that can be used up within its pot life (approx. 20 minutes).

    Apply waterproofing slurry mix in 1xcoat @ 1.0 kg/m. Allow 3 hours drying time between each coats.

    Apply by brush of Formdex Plus, 1x coating

    = Formdex Plus, 1.0 kg/m

  • Hitchins Product Presentation

    Mixing: Add 3 part of powder to 2 part of liquid by volume, and mix thoroughly with a mechanical mixer for at least 3 minutes.

    Mix only sufficient material that can be used up within its pot life (approx. 60 minutes).

    Apply waterproofing slurry mix in 2x coat @ 1.0 kg/m.

    Formdex Uniflex:

    Allow 3 hours drying time between each coats.

    Apply by brush of Formdex Uniflex, 2x coating

    = Formdex Uniflex, 2.0 kg/m

    = Formdex Plus, 1.0 kg/m

  • Hitchins Product Presentation

    = Formdex Uniflex, 2.0 kg/m

    DETAIL - INSTALLATION

    = Formdex Plus, 1.0 kg/m

    Pekerjaan plester pelindung.

    = Lapisan Finishing

  • Hitchins Product Presentation DETAIL - LIGHTING

    = Formdex Plus, 1.0 kg/m = Formdex Uniflex, 2.0 kg/m

    = Epoxy mortar

  • Hitchins Product Presentation DETAIL - PIPE PENETRATION

    = Formdex Plus, 1.0 kg/m = Formdex Uniflex, 2.0 kg/m

    = Epoxy mortar

  • Hitchins Product Presentation

  • Hitchins Product Presentation