- Pull ALL blocks o� of pallet. Place all blocks on their side with plug hole facing up.- Install plugs in each block and tighten with 1 1/8 socket wrench.

Step 2: Block Alignment. Place blocks in the shape of your con�guration with the “Dock Blocks” logo facing up and in the same direction. Blocks will NOT align correctly if logos are not all in the same direction.

FLOATING DOCKING SYSTEMS DRIVE ON DOCKING SYSTEMS

Step 1: Assemble next to water or on trailer that canbe transported to water.

- Pull ALL blocks o� of pallet. Place all blocks on theirside with plug hole facing up.- Install plugs in each block and tighten with1 1/8 socket wrench.

Step 3: Insert bolts through blocks ears.Once bolts are connecting the center half�oater row, �ip that row on its side and puta nut on each bolt. Before laying theblocks back down, place 2 x 4s the lengthof that row under the half �oater row.This will bring the ear of the half �oaterup to the ear of the full �oater.

Step 4: Attach full �oaters tohalf �oaters with bolts.Note: All full �oaters thatattach to half �oaters mustuse bolts and nuts.

Step 2: Place all of your half �oaters in a straightline with the plugged hole located at the topright of each half �oater in that row.

Step 6: Add connecting pins to the full blocks of that 3 row section, use a protected tamper or your foot to stomp the pins in. Lock each pin in with “fork tool”

Step 8: Addstrengtheningbars. The left sideof the bar goesunder the block earand the right side of the bar goes on top of the ear. Insert boltsand tighten with nuts using the “spanner wrench”.

Step 7: Add all of full �oatersleft to complete yourcon�guration, insert pinsand lock into place.

Step 3: Connecting the Blocks. Insert all connecting pins to connect the blocks. Use a tamper with cloth over it to prevent any damage to blocks or stomp the pins in with your foot (Use caution if stomping). After pins are set, use fork tool to lock the pins in.

Step 4: Installing Strengthening Bars. The left side of the bar goes under the block ear and the right side goes over the block ear. Place bolts through bars and block ears, insatll the nuts then tighten with spanner wrench. Push into water and secure.

Congratulations your �oating dock is complete!

Step 1: Assemble on �at surface next to water or on a trailer that can be transported to water.

Step 5: Once all full �oatersare attached to half �oaterswith bolts, turn the 3 rowsection on its side. Makesure it’s secure so it won’tfall over. Oncesecure, install nutson all bolts andtighten with thehalf �oaterwrench. Onceall nuts are tight,lay the 3row section backdown on thebuilding surface.