Fitting Manual

Jacson Cardoso FitFlop Hong Kong

Fitting Guidelines:• Model foot analysis and Process Approval:• Initial foot evaluation will be performed with model standing,• General assessment will include:• Toe length – Size Length – Ball girth – Waist – Instep • Calf and ankle heel with general analysis of arch.• If measurement are 3 mm +/- than Fit Flop Standard the • Model will be performed in the next day.• If approved, Model will be entered in Fit Flop model• Library.

The foot and The Last• The Shoe Last Measures should be accordingly with our Foot

Model Standard• In the illustration we can see a better view and the most used

measure points in the Foot and in the Last.

Fitting Preparation:• Fitting session must take place between 11:00am until 3:00pm

to ensure foot is ideal for fit testing.• Model will be measured standing and wearing appropriate

hosiery• Measurement taken with Brannock or taped prior to fitting

session, if model is 3mm below or above the standard, fit session will be

• Suspended until fitting girl are in right measure.

• Be sure to stand, not sit, when • Take the measurement

Fitting analysis and Approval:

• Approval of Model Fit will consist of the following points:• Fitting location and procedures followed as instructed• All fitting assessments will be performed while model is standing

and repeat again after walking a minimum of 10 paces (steps)• Model and Technical will fill all points indicated on the Fit Test

Report.