f-4 phantom reinforcement panels - nautilus modelsnautilusmodels.com/ra5c/32-701...
TRANSCRIPT
f-4 phantom reinforcement panels For Tamiya Phantom Kits
Nautilus Models #32-701
Thank You for purchasing this Nautilus Product
These panels are designed to better replicate the scab plates applied to all
Navy F-4J, F-4N and F-4S aircraft (and some F-4Bs) as well as what was added to
the USAF F-4E and F-4G aircraft during overhaul. These panels seem ton be
apparent on ALL Phantom variants in their later careers in various Air Forces.
1. Remove the Scab Plates found on the Tamiya kit intakes and fuselage.
2. Add the scab plates as shown in the drawings below.
3. Add the wing spar reinforcing plates (2, 1, & 2) to the bottom of the wing
as shown.
4. Add the centerline reinforcing plate (3) to any Navy Phantom. It is
possible this plate was also installed on the F-4E/G aircraft, but I have
yet to find a definitive photograph that shows it.
If you have any problems, please contact us at: Nautilus Models PO BOX 7958 Marietta, GA 3006 [email protected] http://nautilusmodels.com