electrician lab safety rules for iti
TRANSCRIPT
SDM ITI SAMSEELECTRICAL LAB
IN THIS SLIDESHOW WE ARE
GOING TO LEARN ABOUT SOME OF THE SAFETY MEASURES WE HAVE TO FOLLOW WHILE WE ARE IN AN ELECTRICAL LAB
ELECTRICAL SAFETY
You must not enter a lab unless you have permission from a technician or lecturer.
You are expected to arrive on time and not depart before the end of a laboratory.
You should behave in an orderly fashion at all times in the lab.
You must not stand on the stools or benches in the laboratory.
GENERAL LAB SAFETY RULES
You should inspect laboratory equipment for
visible damage before using it. If there is a problem with a piece of equipment report it to the technician or lecturer. DO NOT return faulty equipment to a storage area
Never strip insulation from a wire with your teeth or a knife, always use an appropriate wire stripping tool.
PERSONAL SAFETY
WE MUST NOT DISCONNECT ANY PLUG BY PULLING FLEXIBLE CABLE
YOU MUST NOT ENERGISE ANY CONDUCTOR UNLESS YOU ARE SURE THAT EVERYTHING IS CLEAR AND NOBODY IS IN CONTACT WITH THAT PARTICULAR CIRCUIT
DO NOT USE A COMBINATION
PLIER AS A HAMMER
REMEMBER TO OFF THE MAIN
SWITCH BEFORE REPLACING THE FUSE
USE SCREWDRIVERS WHEN
WORKING ON ELECTRICAL CIRCUITS
DO NOT TOUCH BARE CONDUCTORS
STAND ON RUBBER MATS WHILE WORKING OR OPERATING WITH ELETRCAL PANELS OR SWITCHES
POSITION THE LADDER ON FIRM GROUND
USE ALWAYS EARTH CONNECTION FOR ALL ELECTRICAL APPLIANCES ALONG WITH 3 PIN SOCKETS AND PLUGS
PRECAUTIONS TO BE
TAKEN IN CASE OF A FIRE Disconnect the supply immediately. Do not throw the water on a live conductor
or equipment. It is dangerous because water is conductor of electricity.
Throw dry sand or dust on the fire equipments.
Use carbon tetrachloride or liquid carbon dioxide type fire extinguishers.
PREVENTING ACCIDENTS
Avoid contact with energized circuits. Disconnect the power source before servicing or repairing
electrical equipment. Work with only one hand, keeping the other hand behind you or
in a pocket If water or a chemical is spilled onto equipment, shut off power
at the main switch or circuit breaker and unplug the equipment. If an individual comes in contact with a live electrical conductor,
do not touch the equipment, cord or person. Disconnect the power source from the circuit breaker or pull out
the plug using a leather belt .
THANK YOU
PREPARED BY :- GURUDATH & SURESHA.N.R