AMPEDTM Bluetooth® Neckband (HLT-NHE-BT Series)

Easy Start Guide

Turning the Device ON

Slide the Power switch to the ON position.NOTE: Fully charge the neckband prior to use.

Once connected, the Bluetooth® Indicator Light flashes blue every 2 seconds to indicate successful pairing.

Pairing First Bluetooth® Device

First the Bluetooth® Indicator Light flashes blue and red to indicate your in the pairing mode.

Next follow your manufacturer's instructions how to connect a Bluetooth® device. Usually this is through your Settings or Control Panel. Find and connect to “Lucid Audio NHE".

If you cannot see a device named "Lucid Audio NHE", press and hold down the Bluetooth® pairing button (middle button on outside left paddle) until Bluetooth® Indicator light flashes.

Then choose the device on phone and press it to make the flash become constant.

Once connected, the Bluetooth® Indicator Light flashes blue every 2 seconds to indicate successful pairing.

Changing the Outside Ambient Sound Level

Volume UP increases the outside sound

Volume DOWN decreases the outside sound

Changing the Outside Ambient Sound Mode

Press both buttons at the same time for one second to change current mode setting. Repeat to advance to the next mode. You will hear the following beeps indicating current mode:

Single beep: Listen Mode (Max 85dB) Double beep: Enhanced Mode (Max 98dB) Triple beep: Boost Mode (Max 104dB)Four beeps: Guard Mode (Max 98dB with Mute - V2 model only)

Play / Pause Music(Short press of the buttons)

Music / Phone Control Buttons

Volume DOWN Volume UP

Phone Call Functions

Middle Button

Answering Call: Short press middle button Rejecting Call: Long press middle button Cancelling or Ending Call: Short press middle button Last Number Dialed: Double press middle button

Volume DOWN Volume UP