I am gonna post a small project in which we will see how to use arduino lilypad library and produce an Arduino Lilypad simulation in Proteus. In this Arduino Lilypad simulation in Proteus, I am gonna use the Arduino Lilypad board along with few LED lightsand will make them blink.
Its also quite easy and you can also download the simulation and the hex file at the end of this project but I would suggest you to do it yourself so that you learn something out of it.
Before starting this project, you must have first integrated the Arduino Lilypad Library as without it you wont be abe to do this project. So, if you havent downloaded it yet thensend me request for source ofArduino Lilypad library in Proteus.
You can clearly see in the Diagram tab, the Arduino Lilypad Simulation in Proteus. After that you need to write a code for Arduino Lilypad so that you could get the hex file for it.
In this project, I have used fiveLED lights and make them ON and OFF using the switch button. If the button is not pressed then the LEDs will remain ON and when you hit the button , the LEDs will go OFF.
[/nextpage]
372 Total Views1 Views Today
Continue:Circuit Diagram
Contents
Page 1:Intro
Page 2:Summary
Page 3:Circuit Diagram
Page 4:Description
Page 5:Code
About the Author
Previous Story
Running Waveform in LCD : Arduino
Next Story
Arduino Library For Proteus
v
