DOT COMPLIANCE SOLUTIONSProducts & Support To Keep Your Vehicles Moving

USA: 866.LAWSON4U (866.529.7664) | Canada: 800.563.1717 | lawsonproducts.com

E1259 V4 (11/19)

Kidde Automotive Fire Extinguisher

3 Triangular Reflectors Kit

Fluid Glow Sticks

Spilfyter Universal Sorbent Kit

Binding Chain Assembly Grade 70

Load Binder Lever Type 9200 lb. Safe Load

Load Hugger® E-Track Assembly, Yellow, 12’ Length

DOT RegulationGeneral requirements for securing loads and cargo are governed by The United Stated Department of Transportation Federal Motor Carrier Safety Administration (DOT FMCSA) Cargo Securement Standard. (393.100-393.136)

SolutionUtilizing the appropriate material handling equipment for the load

Go to lawsonproducts.com/fleet for a Product Information Report on Load Securement

DOT RegulationEach truck, truck tractor and bus must be equipped with warning devices for stopped vehicles except as provided in paragraph (g)* • Three bidirectional emergency

reflective triangles that conform to the requirements of Federal Motor Vehicle Safety Standard No. 125, § 571.125 of this title; or

• At least 6 fusees or 3 liquid-burning flares. The vehicle must have as many additional fusees or liquid-burning flares as are necessary to satisfy the requirements of §392.22

SolutionA kit with reflective triangles and flares

* (g) Restrictions on the use of flame-producing devices. Liquid-burning flares, fusees, oil lanterns, or any signal produced by a flame shall not be carried on any commercial motor vehicle transporting Division 1.1, 1.2, 1.3 (explosives) hazardous materials; any cargo tank motor vehicle used for the transportation of Division 2.1 (flammable gas) or Class 3 (flammable liquid) hazardous materials whether loaded or empty; or any commercial motor vehicle using compressed gas as a motor fuel

DOT/EPA RegulationEPA and the DOT have worked together to develop standards for the transporters of hazardous waste: EPA 40 CFR 263.31Discharge Clean-up - A transporter must clean up any hazardous waste discharge that occurs during transportation or take such action as may be required or approved by Federal, State, or local officials so that the hazardous waste discharge no longer presents a hazard to human health or the environment.

SolutionSpill control products like absorbent pillows, socks, beads, granules and pads

Go to lawsonproducts.com/fleet for a Product Information Report on Spill Containment

PRODUCTS & SUPPORT TO KEEP YOUR VEHICLES MOVING

FIRE EXTINGUISHERS

WARNING DEVICES SPILL CONTROL

LOAD SECUREMENT

DOT RegulationEach truck, truck tractor and bus must be equipped with fire extinguishers (393.95):• A power unit that is used to transport hazardous materials in a quantity that requires placarding must be equipped with a fire extinguisher having an Underwriters’ Laboratories rating of 10 B:C or more.• A power unit that is not used to

transport hazardous materials must be equipped with either

– A fire extinguisher having an Under- writers’ Laboratories rating of 5 B:C or more; or

– Two fire extinguishers, each of which has an Underwriters’ Laboratories rating of 4 B:C or more.

SolutionThe appropriate rated fire extinguisher

with Vehicle Bracket (UL Class Rating 3A:40B:C)

(Packs of 10 sticks) Spilfyter Oil-Only Sorbent Sock

When you see this symbol Find more at lawsonproducts.com

Item No. 81633

Item No. SF10794M10 SF10796M10 SF10795M10

Item No. SF11609

Item No. DH6065

Item No. SF13226

Item No. 1586662

Item No. 26840

Item No. 98662

Spilfyter Universal Sorbent Kit

VEHICLE VISIBILITY

Find over 3,200 moreProducts for Fleet Lighting, Mirrors, Reflectors and Accessories atlawsonproducts.com

Item No. 60176

LED Lamps

Item No. 64037

Item No. 64048

Reflex Reflectors

Item No. 64053

Item No. 99993 Item No. 57989

Conspicuity TapeDOT RegulationEvery lamp, reflex reflector and conspicuity treatment must be permanently attached in the appropriate location and must comply with all applicable requirements prescribed for it by FMVSS/CMVSS 108 (393.11-26)

Solution 1High-intensity reflective tape

Go to lawsonproducts.com/fleet for a Product Information Report on Fleet Lighting

Solution 2Appropriate fleet lighting & spare lamps

Solution 3Appropriate reflex reflectors & spare reflectors

Item No. 12574 Item No. 12573

USA: 866.LAWSON4U (866.529.7664) | Canada: 800.563.1717 | lawsonproducts.com

AIR BRAKE SYSTEM-WEAR & TEAR AIR BRAKE SYSTEM-CHAFFING & KINKING

SPARE FUSES

DOT COMPLIANCE SOLUTIONS

DOT RegulationEach truck, truck tractor and bus must be equipped with spare fuses (393.95)

SolutionCarrying a variety of spare automotive fuses

Automotive Fuses Find hundreds more automotive fuses at lawsonproducts.com

In-Field Repair Air Brake Hose End Fitting Assembly Kit

Lawson Air Brake System Parts Chaf-Pruf Two Hole Air Hose Clamps w/ Vehicle Bracket

Lawson Air Brake System Parts Air Hose Support Springs

Lawson Air Brake Tubing N-2

Complete Offering Of Automotive Fuses

DOT RegulationAir brake systems need to be secured against chaffing, kinking, or other mechanical damage. (393.45)

SolutionUse air hose clamps and springs to reduce chaffing during operation

Air Brake FittingsFind over 5,200 air brake system products in our Fleet Fluid Power section at lawsonproducts.com

DOT RegulationBrake tubing and hose must be long and flexible enough to accommodate without damage all normal motions of the parts to which it is attached. (393.45)

SolutionAir brake components to repair damage in the field and maintain the system back at the shop

Keep extra tubing and the In-Field Repair Kit for emergencies

Air Brakes System Parts Find over 5,200 air brake system products in our Fleet Fluid Power section at lawsonproducts.com

Printers & Label Makers Find over 100 types of printers and labels at lawsonproducts.com

DOT RegulationThe National Highway Traffic Safety Administration places responsibility for labeling an air brake hose assembly in the hands of the assembler of the hose assembly (49 CFR 571.106). (Not the manufacturer of the hose or hose ends.) Each crimped air brake hose assembly must be labeled.

SolutionHave a labeling system on-site to create your own custom hose assembly labels

Go to lawsonproducts.com/fleet for a Product Information Report on labeling crimped DOT hose assemblies

AIR BRAKE SYSTEM-LABELING

®© 2020 Lawson Products, Inc. All rights reserved. Printed in the USA.

Item No. 1674

Item No. 88874

Item No. 52497Item No. 1675

Push-to-Connect Air Brake FittingItem Nos. 55305 & 28979

Go to lawsonproducts.com/fleet to see more product solutions.USA: 866.LAWSON4U (866.529.7664) Canada: 800.563.1717 lawsonproducts.com

Item No. SF16775

BMP™ 71 Label Printer