craig jones - resume
TRANSCRIPT
Craig Jones
Cell: 541.390.3515E-Mail: [email protected]
Structural Aircraft Assembly
Type of work:Experience in Assembling aircraft products within several facets.
Software Used: Microsoft office Suite experience
Experience:
Scaled Composites Stratolaunch programFuel Tank Systems Jul 2016 – Dec 2016 (Contractor)
Precision drilling with use of drill bars, Bombsights, Drill Bushings, etc.
Installation and torque of NAS and Hi-lite fasteners. Damage repair. Fuel Tank Sealant (Pro Seal) Custom trim of Carbon Fiber reinforcement clips Structural and non-structural bond using adhesives with and
without fillers (Pro-set, Cotton flock, and Cabasil) Wet-layup
Zee-Aero (R&D Aircraft) Composite Trim Specialist Oct 2015- may2016
Collaborate with engineering department on trim of all airframe parts
Remove Seal and Release agents from composite parts with Isopropyl and Acetone.
Trim composite parts using various tools (i.e. pneumatic die grinders, cutting wheels, and block sanders with various grit sanding barrels, wheels, and papers)
Bond prep of all bonding surfaces using Aluminum Oxide media blasting, Flapper wheels, and hand sanding with various grit paper and scotch brite.
Time management Quality Control Assist other departments in day to day operations
Epic Aircraft (KIT and Certified Aircraft) Carbon fiber/ Composite Aircraft Assembly And Wet Layup Repair Aug 2012- Oct 2015
Critical fit, functionality testing Fit and Install and Ribs to wing skins, spars, and flight controls Wing fuel systems Using solvents to clean surfaces for bonding and sealing Constant use of various adhesives and resins structural and non-
structural Continuous heavy lifting Use calibrated tools Hand, Power, and Bench tools Clecos and hand clamps Drilling pilot holes, final holes, and countersink composite
parts/assemblies with drill motors Fuselage and wing Joining Install Windows in pressurized cabin Floater between structural assemblies Installation of forward and aft internal assemblies in Fuselage Trim airframe structures to specified trim lines Collaboration With lead and shop floor Hand Fit Flight Controls. Fit and finish Involved with Flight Control counterbalance testing Installation and testing of all flight controls Installation of interior fasteners tooling Design and construction of airframe trim, drill, and router
fixtures.
Cessna (Certified FAA Aircraft) Aircraft Assembly And Wet Layup/ Composite RepairApril 2008- Jan 2009
Collaborating, Engineering, Techs, Paint, Scheduling, Leads Fuselage bonding Window installation Standard install and Emergency field work
non pressurized system Production and Manufacturing of Aircraft products
Columbia (Certified FAA Aircraft) Aircraft Assembly And Wet Layup/ Composite Repair June 2006- April 2008
Fuselage assembly work Interior panel bracket installation Gearbox installations Lighting tape Air ducts riveted and installed Connectivity, Wing fairings, remanufactured Rutter fittings Adjusted trailing edge of the vertical stabilizer Inspections of all associated procedures
Lancair (Certified FAA Aircraft) Aircraft Assembly And Wet Layup Composite RepairMarch 2004- June 2006
Critical fit, functionality testing Structural and non-Structural repairs using 7781 fiberglass,
composites, and 3k carbon fiber Ply orientation Fuel systems in the wing fuel pumps, lines, tank seal Trim and drill work for fit, form, and function Fitment, locating, preparation, and bonding of materials with
structural and non-structural 2-part adhesives
Education:Associates of Applied Science degree in Computer and Information SystemsHigh School Diploma