artwork specification guide for simply plastic cards
TRANSCRIPT
GUIDEKASpecification
Part of the Nitecrest group of companies
85.6mm
54mm
Design size
Front
Back
bleed
CutterSafety
Requirements
Provide PANTONE colour specifications where applicable
Provide 3mm bleed area
All images should be at 300dpi
Provide artwork files in a jpeg, png, tiff or PDF format.
All blacks should be set to 100%
Requirements
Provide PANTONE colour specifications where applicable
Provide 3mm bleed area
All images should be at 300dpi
Provide artwork files in a jpeg, png, tiff or PDF format.
All blacks should be set to 100%
Allow 3mm bleed of artwork around the outside of the cutter. line.
The card will be cut from this line.
No text or logos should be within this area.
All artwork must be supplied in a CMYK colour formatAll artwork must be supplied in a CMYK colour format
No text to be below 6pt in sizeNo text to be below 6pt in size
85.6mm 28.4mm
54mm
Design size M25
Front
bleed
CutterSafety
Allow 3mm bleed of artwork around the outside of the cutter. line.
The card will be cut from this line.
Back
No text or logos should be within this area (1.5mm) .
Design size M6
bleed
CutterSafety
Allow 3mm bleed of artwork around the outside of the cutter. line.
The card will be cut from this line.
Back
85.6mm
70mm
54mm
No text or logos should be within this area (1.5mm) .
Front
85.6mm
54mm
Design size Tritag
bleed
CutterSafety
Allow 3mm bleed of artwork around the outside of the cutter. line.
The card will be cut from this line.
No text or logos should be within this area (1.5mm) .
Front28.54mm 28.54mm 28.54mm
Back
Extras
Mag Stripe
Scratch Panel
Cut out/ slot
4.3mm
12.7mm
8.4mm
Mag Stripe
4.3mm
All slots and cutouts need 1.5mm bleed all around
Our standard size scratch panel is 36x6mm and needs a clearance of 1mm (38x8mm). Within this clearance a white space of 33x4.5mm should be .
Signature Panels can be any size but still need 1.5mm of clearance.
Signature Panel