ArchitecturalArchitectural Design Design Modeling the DesignModeling the Design

Technological DesignTechnological Design

TDJ2O1 – Grade 10TDJ2O1 – Grade 10

Modeling the DesignModeling the Design

• Step 1Step 1– draw out the layout in pencil on the base boarddraw out the layout in pencil on the base board– Show the outline of all walls and doorsShow the outline of all walls and doors– Use a scale of 1:25 (1 foot equals 10 mm)Use a scale of 1:25 (1 foot equals 10 mm)

Modeling the DesignModeling the Design

• Step 2Step 2– draw on the foam board a cut line for the wall draw on the foam board a cut line for the wall

height of 8’ (or 80 mm on the model)height of 8’ (or 80 mm on the model)– then cut out all walls to the required lengththen cut out all walls to the required length

Modeling the DesignModeling the Design

• Step 3Step 3– cut out all entrances and doors to a height of 6’-8” cut out all entrances and doors to a height of 6’-8”

(or 68 mm on the model)(or 68 mm on the model)– when cutting doors, cut only through the foam when cutting doors, cut only through the foam

layer to allow for the paper surface to act as a layer to allow for the paper surface to act as a hinge on one sidehinge on one side

Modeling the DesignModeling the Design

• Step 4Step 4– Cut and place all flooring on baseboardCut and place all flooring on baseboard– Use fabric for carpet or textured paper for flooringUse fabric for carpet or textured paper for flooring

Modeling the DesignModeling the Design

• Step 5Step 5– paint walls a desired color paint walls a desired color

(2 coats may be necessary)(2 coats may be necessary)– glue wall paper on walls with a desired printglue wall paper on walls with a desired print

Modeling the DesignModeling the Design

• Step 6Step 6– paint walls a desired color (2 coats may be paint walls a desired color (2 coats may be

necessary)necessary)– glue wall paper on walls with a desired printglue wall paper on walls with a desired print

Modeling the DesignModeling the Design

• Step 7Step 7– cut wooden sticks to frame up the doorscut wooden sticks to frame up the doors

Modeling the DesignModeling the Design

• Step 8Step 8– cut wooden sticks to add base boards to the wallscut wooden sticks to add base boards to the walls

Modeling the DesignModeling the Design

• Step 9Step 9– use the hot melt glue gun to attach the walls, the use the hot melt glue gun to attach the walls, the

baseboards and door framesbaseboards and door frames

Modeling the DesignModeling the Design

• Step 10Step 10– clean up any blemishes clean up any blemishes

(paint, wall paper, flooring, wall size and shape)(paint, wall paper, flooring, wall size and shape)– add counter tops and any furnishing as desiredadd counter tops and any furnishing as desired