814 itw realease agent

1
ITW PHILADELPHIA RESINS ITW PHILADELPHIA RESINS RELEASE AGENT RELEASE AGENT Technical Bulletin # 814A ITW PHILADELPHIA RESINS RELEASE AGENT prevents adhesion between most ITW Philadelphia Resins' products and surfaces of metal, glass, rubber and many plastics. It is used where the minimum possible clearance between resin and mating surface is required. RELEASE AGENT does not contain silicone oils. When properly used the release agent coating is only a few molecules thick and there is minimal, usually zero, transfer to the cast resin. The aerosol spray can should be held 9" to 12" from the surface and a maximum of 1 second of spray on any given area will be ample. The surface should not appear wet even when freshly sprayed. Do not substitute other release agents for ITW PHILADELPHIA RESINS RELEASE AGENT without testing their effect on adhesion, clearance and surface bubbling. ITW PHILADELPHIA RESINS ITW PHILADELPHIA RESINS 130 Commerce Drive Montgomeryville, PA 18936 215-855-8450 Fax 215-855-4688 All printed statements, data and recommendations are based on reliable information and are presented without any guarantee or warranty. Statements regarding the use of ITW Philadelphia Resins products and processes are not to be construed as recommendations for use in violation of any applicable laws, regulations or patent rights. © All rights reserved.

Upload: pitch-marketing

Post on 15-Mar-2016

217 views

Category:

Documents


4 download

DESCRIPTION

814 ITW Realease Agent

TRANSCRIPT

Page 1: 814 ITW Realease Agent

ITW PHILADELPHIA RESINSITW PHILADELPHIA RESINSRELEASE AGENTRELEASE AGENT

Technical Bulletin # 814A

ITW PHILADELPHIA RESINS RELEASE AGENT prevents adhesion between most ITWPhiladelphia Resins' products and surfaces of metal, glass, rubber and many plastics. It is usedwhere the minimum possible clearance between resin and mating surface is required.

RELEASE AGENT does not contain silicone oils. When properly used the release agent coatingis only a few molecules thick and there is minimal, usually zero, transfer to the cast resin.

The aerosol spray can should be held 9" to 12" from the surface and a maximum of 1 second ofspray on any given area will be ample. The surface should not appear wet even when freshlysprayed.

Do not substitute other release agents for ITW PHILADELPHIA RESINS RELEASE AGENTwithout testing their effect on adhesion, clearance and surface bubbling.

ITW PHILADELPHIA RESINSITW PHILADELPHIA RESINS130 Commerce Drive • Montgomeryville, PA 18936 • 215-855-8450 • Fax 215-855-4688

All printed statements, data and recommendations are based on reliable information and are presented without anyguarantee or warranty. Statements regarding the use of ITW Philadelphia Resins products and processes are not to beconstrued as recommendations for use in violation of any applicable laws, regulations or patent rights. © All rightsreserved.